In short
A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Briarcliff Manor, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Doors that won't close in Briarcliff Manor
Briarcliff Manor sits between the Hudson and the Pocantico, and much of it is hillside. In Scarborough, near the river, older estates and their outbuildings have damp, stone-walled garages. In Chilmark and the hillside subdivisions, mid-century and later homes have garages under the house at the bottom of sloped driveways, where rainwater, leaves and road sand all end up at the sensors. Around the Crossroads and the village center, garages are smaller and busier. West-facing doors above the river also catch strong late sun. A door that reverses only in the late afternoon is looking into it.
Why a garage door refuses to close
- Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
- Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
- Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
- Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.
Quick things to rule out
- Is anything in the path of the beam, even a leaf or a cobweb?
- Are both sensor lights lit and steady?
- Does the problem only happen at one time of day? That points to sun in the sensor.
- Is the wall control's lock or vacation button switched on? It disables the remotes.
Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.
What the technician does
- Checks power and wiring to both sensors and repairs any break.
- Realigns the sensors, or replaces the pair if one has failed.
- Resets the open and close travel so the door seals without straining.
- Tests the automatic reverse on an object in the doorway and with the beam blocked.
Around Briarcliff Manor
- Village center: Around Pleasantville Road's shops, with older homes on smaller lots.
- Hillside subdivisions: Former estate land with curving streets, steep drives and tuck-under garages.
See the full Briarcliff Manor service area.